PT-101Operations and Instructions ManualRevision 112/15/03Designed and Manufactured byEagle Pan Tilt Systems5880 N. Sheridan Blvd.Arvada, CO 80003(303
To set the address by remote control from a PT controller or software, follow this procedure. Theaddress is set by the factory to 1 when shipped. If a
The PT-101 is shipped in standard RS-485 mode; with all of the jumpers UP.Switch all three of the jumpers to the lower position, and the head is now c
360° (left or right 180°), and a tilt range of 180° (up or down 90°); it cannot turn more than a fullcircle. There are end travel stops programmed int
EAGLE™ PT-PS Series Pan Tilt Head—Power Supplies Installation and Operations ManualPRECAUTIONARY STATEMENTImproper settings and connections may cause
Here is the listing of pin configurations for the connector on the power supply output:AMP 4 pin CPC connectorPIN 1 +24 VDC CAMERA POWER SUPPLY TO HEA
FREQUENTLY ASKED QUESTIONS / SETUP PROBLEMSMy pan tilt head was working, but now has stopped responding. I still have a picture fromthe camera, but ha
order to check the balance, and replace it in the correct position.IF YOU ARE EXPERIENCING A PROBLEM NOT COVERED HERE, OR YOU HAVE TROUBLEUNDERSTANDIN
Declaration of ConformityWe, Display Devices Inc., of the United States, confirm that the following products are in confor-mity with the essentia
ContentsIMPORTANT SAFETY INSTRUCTIONS...3ITEMS INCLUDED
PRECAUTIONARY STATEMENT ANDWARRANTYPlease read all of the following documentation before attempting the installa-tion and configuration of these syste
8. Accessories. Do not place this product on an unstable cart, stand, tripod, bracket, or table. Theproduct may fall, causing serious injury to a chil
ing instructions. Adjust only those controls which are covered by the operating instructions asimproper adjustment of other controls may result in dam
ITEMS INCLUDED WITH YOUR NEW PT-101 PAN TILT HEAD:PT-101 PAN TILT HEADADJUSTABLE CAMERA BRACKET2x 1/4”-20 x 3/8” BUTTON HEAD HEX CAMERA MOUNTING SCREW
control ports. Attach the lens control cable from your lens to the connector on the rear of the pantilt head. If you are using a C mount lens with aut
Here is a table showing the types of cameras and lens configurations supported by the PT-101 :NOTE: All Hitachi cameras used with the PT-101 head must
Now you may hook up the wiring to the Eagle™ control system and power supply, using the in-structions included with those devices. If you are using th
Comments to this Manuals