Weather Eagle® 105-110 Instruction Manual Page-11-
Pressing the manual switch and the scan switch AT THE SAME TIME places the
WEATHER EAGLE® into the test mode as if the 1050Hz tone was detected. The reset
LED should flash, the relay should close, and the speaker should unmute, if these
settings were enabled in the configuration mode. Pressing the Reset switch opens the
relay, mutes the speaker and stops the reset LED from flashing.
12) UNMUTED AUDIO OUT
Unmuted audio appears on the rear RCA connector. This is a high impedance output.
The level of this audio output is adjusted by turning the line level potentiometer on the
rear panel. The line level supplies up to 500 millivolts peak to peak of signal. This audio
usually is used to supply audio to EAS/SAME systems and other communications
systems such as intercoms. This audio is NOT controlled by the Live and Reset
switches on the front of the unit.
13) Muted Audio Out
Muted audio appears on the rear high impedance RCA connector. This is a high
impedance output. The level of this audio output is adjusted by turning the volume
potentiometer on the front panel. The line level supplies up to 1 volt peak to peak of
signal. This audio usually is used to supply audio to other communications systems such
as intercoms and public address systems.
14) LAST ALERT RECORD FEATURE
The last warning is automatically recorded into the WEATHER EAGLE® for later
playback. The recording process starts at the end of the 1050 Hz tone. Press the Play
button to play back the last alert. Press the Reset button to stop the playback process. 4
minutes of alert audio is recorded into the WEATHER EAGLE®. If a new alert is
detected while a current alert is being recorded, the WEATHER EAGLE® will record the
© 2006 Thunder Eagle, Inc. All rights reserved worldwide.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals